Return to the Tool Shed Forum | Post a Follow-Up

 o
need info on johndeere chainsaw model 30

Posted by joe_the_dutchman ontario canada (My Page) on
Thu, Feb 4, 10 at 13:07

this model is also an echo cs-302.i can buy it for 50 dollars.looks good but needs a tank to carb fuel line.is that hard to replace on this model.any info on this saw greatly apreciated


Follow-Up Postings:

 o
RE: need info on johndeere chainsaw model 30

Welcome to the Forum Joe !
Can't give you any feed back on the Saw ! Numerous others here on the Forum with yrs of experience . The Gas line to Carb replacement should be rather straight forward . Fishing the internal line with the fuel filter from the Fuel tank is normally the tough part. I usually bend a hook into a small piece of wire to pull it out to check the filter . Be sure to clean out your High and Low Speed Jets. I usually carefully turn the jets in (clockwise) until they just seat. Don't overtighted (damage the seat) or tip of the needle . Be sure to remember the number of turns . Normally anywhere from 1-1/4 to 1-1/2 turns. Remove the jets and carefully spray in some carb cleaner . Replace Jets refuel the saw with properly mixed gas . Never hurts to invest in a new Plug either , always keep previous plug for a back up spare . Once you have the saw running let it warm up by reving it up a little for a few seconds then see how it idles , you may require some fine tuning for the high speed and low speed later on . I normally set the idle speed to where the chain just bearly rolls over .

P.S. I hope that perhaps Tom or CG can get back to you fellow Canuck on the Echo Series Saws , I have seen them advertized but have never ran one.. but for Good Luck Ty !


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Tool Shed Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here