|
| Hello
I have a lightly used gas Delta DTH2450 pressure washer with Honda engine. It ran perfectly for 7 years up until yesterday. Halfway through washing the deck, the high pressure would not work, to the point when you pull the trigger, no water exits the wand in high pressure mode. The unit sprays water in low pressure mode. I checked the water inlet and house water pressure. Both are fine. No leaks from the washer itself. I did some research and think it may be a stuck unloader valve. I want to service it myself. Does anyone know where on the unit the unloader valve is located? Do I need to pull the engine to service the unloader valve or pump? Any recommendations on service related to this issue? Any advice would be greatly appreciated. |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Tool Shed Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.