Return to the Tool Shed Forum | Post a Follow-Up

 o
Ryobi cs30 weedeater won't start

Posted by doug7210 (My Page) on
Mon, May 22, 06 at 16:10

I bought a new Ryobi weedeater over the weekend. After using it for about an hour, the engine died (like it was out of fuel, which it wasn't) and I couldn't get it restarted. Any ideas?


Follow-Up Postings:

 o
RE: Ryobi cs30 weedeater won't start

Not to offend your intelligence, but you did mix oil w/ gas?
Mike


 o
RE: Ryobi cs30 weedeater won't start

Does the engine turn over?

Does the engine have a spark? Take the spark plug out and make sure it is grounded against the engine. Put the engine on and pull the starter cord. There should be a nice blue spark. Be sure you are not touching the spark plug as you do this (you will NEVER forget it again).

Is the spark plug wet with gasoline?

Finally, is the spark plug connected correctly?


 o
RE: Ryobi cs30 weedeater won't start

I had the same problem with a 31 cc Ryobi Blower-Vac. After trying everything (and I DO mean everything) I and every one else could think of, I was ready to replace the ignition module. Just for the heck of it, though, I pulled the plug and squirted a few drops of 30w oil in the cylinder and replaced the plug. It started on the first pull. Smoked pretty good for a while, but after that cleared it ran just as good as it ever did, and now it starts just fine. Still haven't figured that one out, but at least it's running.


 o
RE: Ryobi cs30 weedeater won't start

WoodsRunner, I bet that you had a slightly corroded/dirty spark plug wire connection. You corrected it when you disconnected and reconnected your spark plug wire.

-Deersalyer


 o
RE: Ryobi cs30 weedeater won't start

Nope, I had replaced the plug and cleaned the connections long before. I use dielectric grease in all my electrical connections to prevent that sort of thing. Also cleaned the carb, fuel lines, exhaust screen, etc. and used fresh 2-stroke mix.
Starting it with the oil like that would normally indicate bad rings, but I also know for a fact that they are fine. Just another of life's little mysteries.


 o
RE: Ryobi cs30 weedeater won't start

Either:
Take it back too the box and get your money back.
Or take it too an authorized dealer and have it checked out.
It could be something like a blown flywheel key which you are not going too fix yourself anyhow.


 o
RE: Ryobi cs30 weedeater won't start

I fixed my Ryobi CS30 problem. I cleaned the air filter, and the spark arrestor, and the muffler. I oiled the throttle cable and I still could not get this thing to run correctly. I began to remove the carburetor and noticed that the whole cylinder casing seemed loose. It was very loose (about 1/16" air gap). It is amazing that I could get this thing to run at all.

I tightened the three bolts at the bottom of the cylinder casing, (you have to remove the rear black plastic cover) and now it runs like new.


 o
RE: Ryobi cs30 weedeater won't start

have cs30 also won't start tried all of the above, proper gas, have spark, cleaned arrestor, air filter...ect. cannot manualy pump fuel into cylinder. checked fuel tank,air filter on cap, all vented OK, can start
manually prime cylinder sometimes. IDEAS??????......


 o
RE: Ryobi cs30 weedeater won't start

The cs30 use's a flywheel with the key cast into it. and the cs 31 flywheel won't fit it. It also has a sorry centrifical
clutch, take the thing back and get your money and buy something else.


 o
RE: Ryobi cs30 weedeater won't start

woodsrunner55 im going to try your idea in the am
and thanks to you too roozter im going to check your idea out too i need to get this thing running tomrrow for the boss lady tks agine tommy316


 o
RE: Ryobi cs30 weedeater won't start

See if your shut-off switch is shorting out against metal. Some switches are defective too.


 o
RE: Weedeater edger pe550. Won't start.

I have changed the carburator, changed the fuel line, Had new gas/oil mixture: 40:1. Still not start. Changed spark plub, gap .025. Put a little gas down the plug, it start for a couple of seconds then dies. I can't of anyting elese to try, Help.


 o
RE: Ryobi cs30 weedeater won't start

Ryobi cs-30's in a nutshell.(Engine problems only.)
Blown flywheel keys.
Loose cylinder screws.
Undiscovered carb adjustment screws.
Kinked fuel lines.
Scored cylinders from chips and debri, unfinished ports, air leaks, and out of place piston pin circlips.
And.....A 2 year warranty that any real Homelite dealer has no problem honoring.


 o
RE: Ryobi cs30 weedeater won't start

where is the spark arrestor on a cs30?


 o
RE: Ryobi cs30 weedeater won't start

What is the proper mixture of fuel for the Ryobi CS30 ?


 o
RE: Ryobi cs30 weedeater won't start

The spark arrestor is located between the muffler and the exhaust port. The correct gas/oil mixture if 50:1


 o
RE: Ryobi cs30 weedeater won't start

Where are the carburator adjustments screws? I see 2 things that look like they should be carb adjust screws but they don't have a slit or cross for a flat head or philips screwdriver.


 o
RE: Ryobi cs30 weedeater won't start

itstim,

I have a homelite and my carb screws were just like yours. They had no slit in them, so I cut some slits in them with a dremel tool. Worked like a charm, and now I can adjust it to make it run better.


 o
RE: Ryobi cs30 weedeater won't start

I cleaned the plug and tried ti fill up the tank with mixed gasoline, then started leaking from the bottom of the gas tank. Then I found a circular hole next to the gas line tubing. I feel like something like a washer or something missing there? All it needs to block that hole? would you recommend what I needed to do?
Thanks


 o
RE: Ryobi cs30 weedeater won't start

hellobaba... there is a white plastic washer that goes over the supply line that goes to the carb. that holds the line filter down to the bottom of the tank and keep it from leaking. there should be another line going to tank that is the return line you need both....Hope that helps


 o
RE: Ryobi cs30 weedeater won't start

add fuel stabilizer to the gas can before you put gas into your equipment. our gas has ethanol which eats carburetors.


 o
RE: Ryobi cs30 weedeater won't start

where are the carb adjusting screws located on a 20004 model cs30?


 o
RE: Ryobi cs30 weedeater won't start

MY CS30 WILL NOT RUN AT FULL POWER UNLESS I DEEP PUMPING THE PRIMER


 o
RE: Ryobi cs30 weedeater won't start

MY CS30 WILL NOT RUN AT FULL SPEED WITH OUT PUMPING THE PRIMER


 o
RE: Ryobi cs30 weedeater won't start

DLB: Your carb is fouled , get some carb cleaner and ensure fresh fuel .


 o
RE: Ryobi cs30 weedeater won't start

Hi, I have just managed to find the answer to a similar problem with a blower/vac. Let me start by saying that I've misspent my life around 2-strokes and take these kind of problems as a challenge - my nephew gave me this as he had given up. I F****d about with all aspect of this, the carb, the coil, the exhaust and in the end the problem was the gasket under the barrel! I took the torq screws out and placed a washer under each to stop them from bottoming in the cylinder and therfore clamping the gasket and hey presto it starts first go and the carb progression is okay.
I don't say this is the answer to all of these problems but it certainly worked on mine, give it a try. Good luck.


 o
RE: Ryobi cs30 weedeater won't start

Ryobi has had a problem the last couple of years with providing the wrong oil with some of their weed eaters which caused them to seize up after a short time. It's a known problem, but we still see them on the shelves at Home Depot. We found this out by calling Ryobi. Home Depot easily accepted the return, but we had to sort through the stock to find one with the correct oil.


 o
RE: Ryobi cs30 weedeater ..broke the pull string

I can't get to the pull string on my ryobi CS30..its been great..They say you cant get to the pull cord ..Is that true?? Man I hope not..please HELP..


 o
RE: Ryobi cs30 weedeater won't start

I have a SS30, model RY30550. It starts ok when I first use it but once I shut it off I can't restart it until it cools off. What's the problem?


 o
RE: Ryobi cs30 weedeater won't start

to say the least these weed whackers suck ! i have the ry30550 and i used it 4 times and now its back firing after a few seconds of it being started then it dies!when i restart it the same thing back fire n die ! if anyone has any ideas please email me and fill me in ! im ready to drive this thing to the walt witman an toss it over board !!!!!!! this is what i get for ever steering away from a echo!


 o
RE: Ryobi cs30 weedeater won't start

This Thread should e a Memorial Site for Ryobi Trimmers lol. Got my 1st one in this weekend from a neighbor , Hell I thought the Ole Weed-eaters where shabby these things are pure Rubbish ! I told him to return to buying Quality units , apparently his Son in Law Purchased it for him for Father's Day !


 o
RE: Ryobi cs30 weedeater won't start

I have 3 dead Ryobi weed eaters in the shed. I have experienced most if not all of the problems described here. I keep getting sucked in to buying another one since I have many the attachments. Finally after reading this blog I have decided it is just NOT WORTH IT. I just bought another 4 stroke Ryobi and am going to return it since I haven't opened it yet I AM GOING TO PAY THE EXTRA BUCKS AND BUY AN ECHO! Best luck to all!


 o
RE: Ryobi cs30 weedeater won't start

4 strokes usually are alot better. I got one I've had for 11 years and haven't done anything to it except change the oil and put gas in it. Starts every time on second or third pull. Would I buy another??? probably not. Seems Like they get cheaper as the years go by????? How I don't know but they manage to do it!!!!!!!!


 o
RE: Ryobi cs30 weedeater won't start

Hi Guys
Sorry to but in but new to this forum and not sure were to post this" Royobi RBL30BPT BLOWER WILL NOT START, I have a spark, clean petrol mixed 50/1 like it says on the cap, I just bought this off a carboot today, the guy said it runs just need new petrol, so I change the old petrol and cleaned the carb, it starts after alot of pulling only on full choke, and will only run on choke, spits petrol out of the carb when the airfilter is not fitted, when reved up it stalls and will not restart, only after hour of pulling it!!! when it was running I restricted the blower output and the engine reved up , then down again when unblocked the blower output. can any one help please??? what am I missing?
Richie


 o
RE: Ryobi cs30 weedeater won't start

May sound like a stupid question but my cs 30 won't start and I drained the gas tank first. Then I saw two lines inside the gas tk. one had the fuel filter attached at the end of the line. The other only goes into the tank about maybe 1 inch or inch and a half at the top of gas tank. Is this short line supposed to go in further?


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Tool Shed Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here