Return to the Tool Shed Forum | Post a Follow-Up

 o
Troy horse tiller transmission

Posted by gampopa (My Page) on
Sat, May 22, 10 at 20:12

I have a '85 Troy bilt tiller model # 195432 which needed to have the main power shaft replaced. I was able to disassemble the transmission and order new parts. On the new drive shaft the bearing and cup nearest the worm is already mounted. There is another bearing and cup that needs to be mounted but I'm not sure how to do it w/o damaging it because the shaft widerns slightly where the bearing rests. I suspect this is where the bearing locks into place on the shaft but how do you get it on there?


Follow-Up Postings:

 o
RE: Troy horse tiller transmission

  • Posted by mla2ofus z7b Tom Green Co.,Tx (My Page) on
    Sat, May 22, 10 at 22:23

With the OK of the "BOSS", Put the bearing in the oven @ 400* put the shaft in the chest freezer if you have one for a couple of hours. Hold brg w/ a heavy leather glove and slip it on the shaft immediately after taking both out of their respective heating/ chilling areas.
Mike


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Tool Shed Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here