Return to the Tool Shed Forum | Post a Follow-Up

what going on with this battery?

Posted by rbigg (My Page) on
Thu, Jul 15, 10 at 12:50

Got a simple question, but one in which I'm not sure I know the answer to.

I have a tractor battery that was flat. No life at all in it.

Brought it in the garage, and put a small chargers on it (upt to 8 amps). I used three different ones, and none would even move the needles to show it was taking a charge. The three chargers are still good, as I sparked the leads after using. The needles jumped when I did that.

The battery went to Auto Zone. They are charging it now. Said come back in an hour.

What is going on with the charge cycle in the battery?
The three chargers I used could be too small. Just curious as why my small chargers wouldn't charge this battery.

Follow-Up Postings:

RE: what going on with this battery?

Some of the small chargers need to see a tiny bit of current coming from the battery or they won't work. This is done to protect against polarity reversal and short circuiting of the charger leads.

Places such as Autozone use much larger chargers that are often more sophisticated. I don't agree with them putting this on a fast charge though, because it was apparently dead flat. Total discharge is the worst thing that you can do to a battery. You need to figure out how this happened to make sure it does not happen again. Every time it does happen, is like driving another nail in that batteries coffin.

You will not get a long lifespan from it because the plates are being stripped of their material. That can only go on for a certain before you end up with a weak cell, then a dead or shorted cell. At that point, it's new-battery time.

RE: what going on with this battery?

Good explanation. Thanks. It's one of my son's tractors. He lets 'em sit without running, hot when it's hot, cold when it's cold. I hope I've got him bringing it to the barn and putting a trickle charger on it.

RE: what going on with this battery?

This Renaissance device will restore a dead battery:
It is much more than just a charger. I had two car batteries that were dead and in my junk pile and I restored them both with this charger (which is more like a rejuvinator). Now they both are at ~12.6 volts and hold a charge.

RE: what going on with this battery?

Those are some pretty extravagant claims for a charger that costs as much as that one does. What surprises me is that this is the first time I've heard of this charger. When you consider the current "green movement", one would think that the media would be all over this charger. If it actually does what they claim it does, then someone could set up a battery rejuvenation business whereby customers could drop off their dead batteries and return a day or so later to retrieve them after paying a small fee.

I bet that I have about 20 cordless tool batteries from Milwaukee, De Walt and Makita kicking around that are in need of restoration. I've stopped using those tools because the cost of replacement batteries is just too high.

The forklift truck industry should also be excited about this technology as should every golf course that uses battery powered carts with six 6 volt lead-acid batteries in each one. Did you subject your batteries to a load test after you recharged them with the Renaissance unit?

RE: what going on with this battery?

Ahh, yes, the battery rejuvenator trick! Sounds great! Will save lots of money, after you buy it!
BUT---------When the lead on the plates inside the battery finally all fall off, your trick charger you just bought, will no longer charge that battery, nor any other one, if they are in the same condition! At that time---you can recharge that battery until yer hair falls out, and although you might get a short amount of time from the battery--it ain't gonna last! Also, the one aspirin tablet in each hole on top of the battery is a joke. Also, the dumping of the liquid inside the battery, washing it out with a garden hose, and filling it with fresh water, is an old wives tale! Bite the bullet--buy new!!

RE: what going on with this battery?

10-4 and Amen Rusty ! :)

 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!

Return to the Tool Shed Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.

Learn more about in-text links on this page here