Troy-Bilt
Outdoor_Lady (Nevada)
9 years ago
More Discussions
Hi all,
Have read in depth the post (and fix) for this issue on a Karcher, but before I start to dismantle anything, can anyone verify for me where the 'unloader' is located on my pump? The guy at Lowe's described (over phone) 'E' on Page 5 of the diagram in link below (forum won't accept pdf file)... it's brass.
Also, at one brief point, there was water coming out of the nipple of a black cap attached to a short threaded pipe on the lower back of the pump (not shown in diagram); it doesn't do that any more. Have used pump saver/cleaner and run two tanks of water/vinegar mixture (2:1); still not adequate pressure.
I'm in So. Florida, so no freeze issues. Very low hours & usage. Hose was run 1 min. before hooking up. It ran full pressure for a bit and then lost it. Guessing something in there is clogged up and/or stuck. Any thoughts appreciated.
Here is a link that might be useful: Troy-Bilt Pressure Washer Parts List
hippy
Outdoor_Lady (Nevada)Original Author
Related Professionals
Clark Landscape Architects & Landscape Designers · Cottonwood Landscape Architects & Landscape Designers · Ferndale Landscape Architects & Landscape Designers · New Mexico Landscape Architects & Landscape Designers · Alexandria Landscape Contractors · Amesbury Landscape Contractors · Belvedere Park Landscape Contractors · Columbine Landscape Contractors · Gloucester Landscape Contractors · Severna Park Landscape Contractors · Teaneck Landscape Contractors · Watertown Landscape Contractors · Norridge Landscape Contractors · Franconia Decks, Patios & Outdoor Enclosures · Spanish Springs Home BuildersOutdoor_Lady (Nevada)Original Author