|
Wed, Dec 23, 09 at 15:11
| I am looking for a diagram and/ or instructions to re-build a carburator for a Toro S-200 Electric Start snow blower Model 38130. I've tried to order a new carb, but was told that the part was discontinued. Any help will be greatly appreciated. Thanks! |
Follow-Up Postings:
|
| All you normally need on these is the diaphragm kit along with the needle and seat kit if desired. The adjuster screws have common Tecumseh seals if you need them also. Common Tecumseh parts. Watch what side of the diaphragm the gasket goes and you will be fine. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Tool Shed Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.