Return to the Tractors Forum | Post a Follow-Up

 o
Riding Mower Will Not Start - Questions

Posted by genx80s none (My Page) on
Sun, Feb 17, 13 at 19:43

I have a tractor type Snapper riding mower from about the mid 90s. I do not know much as far as how to repair a mower and was hoping to get some guidance on this forum. I have been trying to remember to start the mower periodically during the winter and let it run a little while. Up until today, it was starting fine. I let more time go by from the last time I started it then I intended to (about 6 weeks or so). The engine will turn when I try to start it but it will not start. I checked the fuel line to see if gas was flowing through it. I disconnected the fuel line and gas flowed out of it. I took the bowl on the bottom of the carburetor off and checked it. There was gas in it. The bowl looked clean. Given this, what could be the cause of it not starting? Could this be caused by a bad spark plug?


Follow-Up Postings:

 o
RE: Riding Mower Will Not Start - Questions

I also checked the oil, and it was fine. The air filter also looked clean.


 o
RE: Riding Mower Will Not Start - Questions

Identifying the engine could be useful!

Try priming the carb with a couple teaspoons worth of gas.


 o
RE: Riding Mower Will Not Start - Questions

Sometimes, a liberal shot of starting fluid will help to wake it up. Thats what i use in the Spring, after winter storage.
Although: If you had it stored in an outside shed or garage, the resident mice may have made a home in the flywheel area of the engine. They just love to make their home under the round tin flywheel cover on the engine. They are safe there from cats and other creatures that would like to have them in for dinner! They also seem to relish the taste of the main spark plug wire insulation, as i have found those wires gnawed bare, That kills the spark as effectivly as turning off the key. If you find that situation, you will have to clean out around the fins, and down in their toilet hole. A good strong blow out with compressed air will usually suffice!


 o
RE: Riding Mower Will Not Start - Questions

Rusty!!! With all due deference to yer age/experience, starting fluid is not good for small gasoline engines. Mownie will haunt you. Rattlecan carb cleaner is a better choice - much less chance of engine damage.
Needless to say, all the rest of yer advice is spot on...


 o
RE: Riding Mower Will Not Start - Questions

Yep, unless you have a heavy duty Cummins diesel on yer tractor............keep yer diethyl ether starter fluid on yer shelf.
In all fairness though, and to clarify somewhat, The use of ether based starting fluid in all kinds of gasoline powered engines is NOT AS LIKELY to cause damage if used sparingly when the temperatures of the engine and ambient air are 20 degrees Fahrenheit or colder.
The explosive blast that can break piston rings and stress other parts is less apt to occur when the temperatures are that cold.
Where people stand the most risk of doing damage is when they use ether starting fluid at higher ambient temperatures or they feed it to an engine that has already been run and warmed up. Another factor that can increase the risk of damage from ether is is the spark timing. If there is a condition/defect causing the spark to occur earlier than normal...........the chances of breaking things increases significantly.
A shot of the commercially available spray can carb cleaner is much gentler on the engine than ether.
It comes down to this: Diesel engines are built a lot heavier and designed to handle much higher combustion chamber pressures than a paltry little gasoline powered engine.
A shot of ether exploding in a diesel engine is like a firecracker to that engine.
A shot of ether exploding in a gasoline engine is more akin to dynamite.


 o
RE: Riding Mower Will Not Start - Questions

It's best to use a gas stabilizer in the gas tank before storing for awhile. Or drain it out completely including carb. Stored gas for several months gums up and will interfere with proper carb function. It can get so gummed up a carb cleaning may be required. Every spring, I get calls to ungum a carb where the owner neglects to use a gas stabilizer.


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Tractors Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here