Return to the Tractors Forum | Post a Follow-Up

 o
Scag Freedom Z battery size?

Posted by taylorkh NC (My Page) on
Thu, Mar 27, 14 at 11:54

Can anyone tell me the battery size group for this mower? The battery in my 2007 Freedom Z with the 26 HP B&S engine seems to be on its last legs. The only sticker on the battery says "F-7". An on-line search has not been of much help. I found one site AZ battery store which claims it uses a U1-35. The U1 is the size of a generic riding mower battery. However, the U1 size is NOT the size of the Freedom Z battery, nor is it the same type. The Freedom Z battery appears to be a large motorcycle type battery.

I guess could go to the Scag dealer but I sort of hate to do that for a commodity item especially if I do not have any prices to compare to the dealer's offerings.

TIA,

Ken


Follow-Up Postings:

 o
RE: Scag Freedom Z battery size?

Measure your battery dimensions and look on the chart at the link below to find a matching group number.
Your mention as a "large motorcycle battery" sort of leads me to think of a group 22 battery.

Here is a link that might be useful: Some battery sizes chart


 o
RE: Scag Freedom Z battery size?

You mention Briggs.
Briggs OHV engines require the valves to be properly adjusted for the compression release to function.
Many a battery & starter motor has been replaced on these engines NEEDLESSLY.
Your battery may be on its last legs, but you can get it load tested for free at many battery retailers/auto parts stores.
I'd suggest you do that if the valve adjustment doesn't work.


 o
RE: Scag Freedom Z battery size?

Thanks folks! The battery link will be real handy, and not only for this situation.

As to the valves... It was 26 degrees the night before and the battery is 7 years old. About 30 minutes on the charger and the machine fired up just fine. I will check my maintenance log to verify that I checked the valve adjustment on schedule.

Back to the battery size - my bad. I dipped my tape measure down the side of the battery to measure the depth of the battery box. It must have hung up on something as I had recorded 7" which is less than the height to the top of a U1 size battery. I searched the Scag manual and found that the battery is "not stocked by Scag" according to a parts diagram.

I called the dealer and was told they use "a 12 volt Exide battery" to replace OEM battery in Scag mowers. Not entirely helpful. I then started to make the rounds of the auto parts stores to see if they could match the battery. At the first store the clerk said it was a U1. I indicated that my (incorrect) measurement showed a U1 to be too tall. Upon close examination of the OEM battery they found U1 and some other numbers vibra penciled on the top of the battery case. A re-measurement showed that a U1 would in fact fit. However...

There are several U1 species. The store had a U1 rated for 12 HP, a U1H rated for 19 HP and a U1JD (John Deere) rated for 35 HP. I went to the the Scag dealer next to find out which U1 battery was correct. They stated it should be 325 CCA. the one they had in stock was 300 CCA.

Bottom line... I will run the current battery until I get all the goody out of it. Then I my replace it with a U1 "riding mower battery" although they only have a 30 day warranty. Or I may spring for an AGM battery which is a little more resistant to vibration and generally carries a better warranty. Although 7 years from a U1 is not too bad.

Thanks again,

Ken


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Tractors Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here