|
Wed, Apr 18, 12 at 17:12
| I have an older craftsman 42" lawn tractor. My husband replaced both of the blades. Now one bade hits the edge of the deck just slightly. The blade does not seem to slide on and fit like it should. What could be the problem? The other blade slid on exactly how it should. |
Follow-Up Postings:
|
| I have no way of knowing what blade you have, but alot of the Craftsman riders use a rounded star pattern. If the blades aren't properly installed, these star patterns get worn down on the arbor and it's possible to install that blade off center. Check again. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Tractors Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.