mower wont start without bypassing switch.have current from switch and have disconnected safety switches.no fusable link found.wires need to be redone from switch to selenoid ect.need wiring diagram or insight.thanks

start by looking in the cavity under the tilting seat, getting the full model number and serial number.
post same here so that we even know what make/model we ware dealing with. Someone may have or can direct you to such then.

Well first off, most of these forums do not condone posting messages about bypassing safety devices.

The small terminal on the starter solenoid must receive 12 volts to activate. One of the posts on your switch will produce 12V when the switch is held in the Start position and only when held in Start position.

Walt Conner