Walt will probably come along and email the instructions if you give him an email address. HIs instructions are great.

I believe your spec is 0.003" to 0.005" clearance for the intake valve and 0.005" to 0.007" for the exhaust valve. The intake valve will be your bottom valve and the exhaust will be the top.

The clearances are set with the piston at 1/4" past top dead center after the compression stroke.

This post was edited by optsyeagle on Wed, Sep 4, 13 at 14:45

You have to email Walt first, stating what you want & engine#'s.
He'll then attach your instructions in a return email.

Look for Walt Connor

This post was edited by bill_kapaun on Wed, Sep 4, 13 at 15:09

OP - Ditto above posts... try contacting Walt via email (put in proper format):
wconner5 at frontier dot com

Include your engine model specifics model/type/etc and what you need in the way of instructions...

I have a similar question- is thi Walt still available?

Yes, wconner5 at frontier dot com